Specifications - Makita HM1203C Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Switch lever
2-1. Adjusting dial
3-1. Power-ON indicator lamp (green)
3-2. Service indicator lamp (red)
4-1. Side handle
4-2. Clamp nut
5-1. Bit shank

SPECIFICATIONS

Blows per minute
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for chiselling work in concrete, brick,
stone and asphalt as well as for driving and compacting
with appropriate accessories.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
For Model HM1213C
For European countries only
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 2.5 dB(A)
Wear ear protection
Vibration
The vibration total
determined according to EN60745-2-6:
Work mode : chiseling function with side handle
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Explanation of general view
5-2. Bit grease
6-1. Releasing cover
8-1. Releasing cover
9-1. Change ring
12-1. Screws
13-1. Connector
13-2. White
Model
Overall length
Net weight
Safety class
) : 75 dB(A)
pA
) : 95 dB(A)
WA
value (tri-axial vector
2
) : 7.0 m/s
h,CHeq
2
HM1213C
10.8 kg
ENE045-1
For Model HM1203C
For European countries only
Noise
The typical A-weighted noise level determined according
ENF002-1
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 2 dB(A)
Vibration
The vibration
determined according to EN60745-2-6:
Work mode : chiseling function with side handle
Vibration emission (a
ENG102-2
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
ENG216-1
The vibration emission during actual use of the
•
sum)
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
4
13-3. Black
14-1. Screwdriver
14-2. Crank cap cover
15-1. Grease
16-1. Connector
16-2. White
16-3. Black
HM1203C
-1
950 - 1,900 min
576 mm
9.7 kg
II
) : 81 dB(A)
pA
) : 95 dB(A)
WA
Wear ear protection
total value (tri-axial
) : 15.5 m/s
h,CHeq
2
ENG102-2
ENG216-1
vector sum)
2
ENG901-1