Specifications; Ec Declaration Of Conformity; Specific Safety Rules - Makita HM0810 Bedienungsanleitung

ENGLISH
1-1. Lock button
1-2. Switch trigger
2-1. Side grip
3-1. Bull point
3-2. Tool retainer
4-1. Red dot (Tool holder)

SPECIFICATIONS

Blows per minute
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
Intended use
The tool is intended for chiselling work in concrete, brick,
stone and asphalt as well as for driving and compacting
with appropriate accessories.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
For Model HM0810,HM0810B
For European countries only
EC-DECLARATION OF CONFORMITY
We declare under our sole responsibility that this
product is in compliance with the following standards of
standardized documents;
EN60745, EN55014, EN61000 in accordance with
Council Directives, 89/336/EEC, 98/37/EC.
Measured sound power level: 99 dB
Guaranteed sound power level: 105 dB
These sound power
accordance with Council Directive, 2000/14/EC.
Conformity assessment procedure: Annex VI
Notified body: BSI Product Services, Maylands Avenue,
Hemel Hempstead HP2 4SQ, England
Vibration
The typical weighted root mean square acceleration
2
value is 9 m/s .
This value has been obtained according to EN60745.
Yasuhiko Kanzaki CE2005
Explanation of general view
4-2. Red dot (Tool retainer)
5-1. Tool retainer
6-1. Commutator
6-2. Insulating tip
6-3. Carbon brush
7-1. Hex wrench
Model
Overall length
Net weight
Safety class
levels were measured
HM0810
2900 min
410 mm
5.3 kg
ENE045-1
000087
ENF002-1
MAKITA INTERNATIONAL EUROPE LTD.
Michigan Drive, Tongwell, Milton Keynes, Bucks MK15
8JD, ENGLAND
Responsible manufacturer:
Makita Corporation Anjo Aichi Japan

SPECIFIC SAFETY RULES

DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to hammer safety rules. If you use this tool unsafely
ENH112-5
or incorrectly, you can suffer serious personal
injury.
1. Wear ear protectors. Exposure to noise can
cause hearing loss.
2. Use auxiliary handles supplied with the tool.
Loss of control can cause personal injury.
3. Hold power tools by insulated gripping
surfaces when performing an operation where
the cutting tool may contact hidden wiring or
its own cord. Contact with a "live" wire will make
exposed metal parts of the tool "live" and shock
in
the operator.
4. Wear a hard hat (safety helmet), safety glasses
and/or face shield. Ordinary eye or sun
glasses are NOT safety glasses. It is also
highly recommended that you wear a dust
mask and thickly padded gloves.
5. Be sure the bit is secured in place before
operation.
6. Under normal operation, the tool is designed
to produce vibration. The screws can come
loose easily, causing a breakdown or accident.
3
7-2. Rear cover
8-1. Screwdriver
8-2. Brush holder cap
9-1. Lock nut wrench
9-2. Crank cap
10-1. Hammer grease
HM0810B
-1
2900 min
433 mm
II
Director
-1
5.3 kg
GEB004-2