Dust Extraction - Makita 4326 Bedienungsanleitung

Metal cutting
Always use a suitable coolant (cutting oil) when cutting
metal. Failure to do so will cause significant blade wear.
The underside of the workpiece can be greased instead
of using a coolant.

Dust extraction

Fig.17
Clean cutting
connecting this tool to a Makita vacuum cleaner. Insert
the hose of the vacuum cleaner into the hole at the rear
of the tool. Lower the dust cover before operation.
NOTE:
Dust extraction cannot be performed when making
•
bevel cuts.
Rip fence (optional accessory)
CAUTION:
Always be sure that the tool is switched off and
•
unplugged
accessories.
1. Straight cuts
Steel base type
008096
When repeatedly cutting widths of 160 mm or less,
use of the rip fence will assure fast, clean, straight
cuts.
Aluminum base type
008097
To install, insert the rip fence into the rectangular
hole on the side of the base with the fence guide
facing down. Slide the rip fence to the desired
cutting width position, then tighten the bolt to
secure it.
Downloaded from www.Manualslib.com
operations can be performed
before installing or
1. Rip fence
(Guide rule)
1
1. Rip fence
(Guide rule)
1
manuals search engine
by 3
002776
Aluminum base type
1
2
005454
removing
2. Circular cuts
2
3
002777
Aluminum base type
4
005455
Steel base type
1
008098
8
1. Hex wrench
Steel base type
2. Bolt
3. Rip fence
1
(Guide rule)
4. Guide facing
4
2
1. Bolt
2. Fence guide
3. Hex wrench
4. Rip fence
(Guide rule)
3
4
1. Treaded knob
Steel base type
2. Guide facing
3. Rip fence
(Guide rule)
4. Pin
1
4
1. Threaded knob
2. Pin
3. Rip fence
(Guide rule)
4. Fence guide
1
2
3
1. Rip fence
(Guide rule)