Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• Unscrew nut
5 (Fig. C - Fig. E)
while being very careful because
the clutch assembly
from the contrast spring
C - Fig.
F);
• Insert the new Malossi clutch
in place of the original and
reassemble the whole assembly
with the belt as it was originally.
• Insert the new Malossi clutch
bell in place of the original (if
included in kit).
Clutch adjustment
The Malossi clutch is supplied with
an intermediate adjustment of the
coupling revs number for your
vehicle; in case one wants to vary
the coupling revs number on the
basis of one's own needs, by using
the attachments
(page
possible to find the fixing position
both of the spring adjustment
of the additional mass 4.
To perform adjustment, it
is necessary to completely
disassemble the clutch,
proceeding as indicated in the
fitting instructions:
6
protrudes
(Fig.
(Fig. D)
26) it is
3
and
9
1)
After having slackened fixing
screw 1, elongate spring
a seeger pincer and extract it.
2)
Using a small screwdriver
extract retainer
clutch mass
6
3)
Place spring adjustment
position and the additional
mass
4
in the position
determined in the graphs.
4)
Tighten screw
additional mass
adjustment 3.
5)
Re-fit clutch masses
pin 7, reinsert retainer
springs 5.
6)
Proceed in installing the
complete clutch assembly as
per fitting instructions.
Art. 5214113 - 7711166
Art. 5214739 - 7714313
Attention: in order to use Malossi
clutch bell it is necessary to remove
surplus material from the internal of
the crankcase.
5
with
2
and remove
from its pin 7.
3
in
1
to fix
4
and spring
6
on
2
and
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
