Setting Up The Freezer En; Changing The Door Hinges En - hanseatic HGS14355FW Gebrauchsanleitung

Setting up the freezer
Changing the door hinges
WARNING
Risk of electric shock!
To change the door hinges, you will need to remove
the cover from the freezer. Live parts can become
accessible by doing so.
• Pull out the mains plug before starting to change the
door stop.
The door hinges are on the right upon delivery. As changing the
door hinges requires some manual skills, please read through
the steps of the procedure beforehand. To change the door
hinges, you will need the following tools:
– Cross-head screwdriver
– 8 and 10 mm open-end wrench or socket wrench
1. Pull out the blind plug from the top of the door.
2. Loosen both screw covers on the top of the cover using a
screwdriver.
3. Unscrew the two screws (on the left and right) from the top of
the cover. To do this, use a cross-headed screwdriver.
4. Lever out the two sides of the cover on the front slightly and
lift the cover up. In doing so, ensure you do not damage the
temperature controller 1.
5. Unscrew the three fixing screws for the hinge plate and the
two screws on the opposite side. To do this, use an 8 mm
spanner or a cross-head screwdriver.
Remove the hinge plate.
HGS14355FW, HGS14355FS
Setting up the freezer
EN-11