Installation; Operation - Kärcher BLV 18-200 Battery Originalbetriebsanleitung

Motor casing
7
Motor casing locking pin
8
Upper blower and suction pipe
9
Fixing screw for suction pipe
10
Front handle
11
Eyelet for carrying belt
12
Turbo boost button
13
Speed regulation
14
Rear handle
15
Trigger
16
Selector switch for blower / suction mode
17
Connecting piece
18
Adapter for collecting bag
19
Collecting bag
20
*Battery Pack Battery Power 18V
21
*Quick Charger Battery Power 18V
22
* optional
Rechargeable battery pack
The device can be operated with a 18 V Kärcher Bat-
tery Power battery pack.

Installation

Installation of blower / suction device
WARNING
Risk of injury due to incompletely assembled de-
vice
Only operate the appliance once it is fully assembled
and functional.
1. Push the lever down and snap the blower pipe into
the adapter of the guide rollers in the desired posi-
tion.
Illustration B
2. Allow the adapter for the lower suction pipe to click
into place in the mounting for the blower pipe.
Illustration C
3. Allow the lower suction pipe to click into place in the
upper blower and suction pipe.
Illustration D
4. Install the motor casing.
Illustration E
a Pull out the motor casing locking pin as far as
possible.
b Insert the blower and suction pipe into the motor
casing.
c Insert the motor casing locking pin and check that
it is correctly seated in the holder.
d Insert the suction pipe fixing screw and tighten it
until it clicks audibly.
The safety button has tripped.
5. Install the collecting bag, see chapter Installing the
collecting bag.
6. Attach the carrying belt to the eyelet on the handle,
see chapter Hooking the carrying belt.
Installing the collecting bag
1. Install the collecting bag.
Illustration F
a Hook the tab of the collecting bag into the eyelet
on the upper blower and suction pipe.
b Pull the collecting bag on the adapter over the
connecting piece.
c Allow the adapter to click into place.
Hooking the carrying belt
1. Hook the carrying belt into the eyelet on the handle,
making sure the quick release is accessible at all
times.
Illustration G
WARNING
Risk of injury due to incompletely assembled de-
vice
Only operate the appliance once it is fully assembled
and functional.
CAUTION
Risk of injury from objects flying about
Wear safety goggles and suitable protective gloves for
all work with the device.
The cordless aspirator has the following control ele-
ments:
● A speed control lever to regulate the speed of the
airflow steplessly.
● A turbo boost button to maximise the air speed set
with the speed regulation.
● A selector lever to switch between the blow and suc-
tion modes.
Inserting the battery pack
ATTENTION
Dirty contacts
Damage to the device and battery
Check the battery mount and the contacts for soiling
and clean them as necessary before inserting the bat-
tery.
Illustration H
1. Push the battery into the mounting in the device until
it audibly latches into place.
Switch on the device (suction mode)
CAUTION
Risk of injury from flying parts and hearing damage
due to noise
Always wear eye and hearing protection.
WARNING
Risk of injury due to loss of control
Always hold the device with both hands on the provided
handles.
1. Insert the battery pack, see chapter Inserting the
battery pack.
2. Start the device.
Illustration I
a Set the selector lever to suction mode.
b Press the trigger.
The device starts up.
c Use the speed regulation to adjust the amount of
airflow.
d If necessary, press the turbo boost button for
maximum flow speed.
English

Operation

Control elements
15