Description Of The Device; Installation - Kärcher BLV 18-200 Battery Originalbetriebsanleitung

Do not subject the device to rain or moist
conditions.
Danger due to flung objects. Keep spec-
tators away from the work area.
Rotating fan wheels. Keep hands and
feet away from the openings while the
device is in operation.
The guaranteed sound level specified on
the label is 107 dB.
Pull: Quick-release catch
Vacuuming operations
Blowing mode

Description of the device

The maximum amount of equipment is described in
these operating instructions. Depending on the model
used, there are differences in the scope of delivery (see
packaging).
See graphics page for illustrations
Illustration A
Carrying belt
1
Guide rollers
2
Lower suction pipe
3
Blower pipe
4
Battery pack unlocking button
5
Type plate
6
Motor casing
7
Motor casing locking pin
8
Upper blower and suction pipe
9
Fixing screw for suction pipe
10
Front handle
11
Eyelet for carrying belt
12
Turbo boost button
13
Speed regulation
14
Rear handle
15
Trigger
16
22
Selector switch for blower / suction mode
17
Connecting piece
18
Adapter for collecting bag
19
Collecting bag
20
*Battery Pack Battery Power 18V
21
*Quick Charger Battery Power 18V
22
* optional
Rechargeable battery pack
The device can be operated with a 18 V Kärcher Bat-
tery Power battery pack.
Installation of blower / suction device
WARNING
Risk of injury due to incompletely assembled de-
vice
Only operate the appliance once it is fully assembled
and functional.
1. Push the lever down and snap the blower pipe into
the adapter of the guide rollers in the desired posi-
tion.
Illustration B
2. Allow the adapter for the lower suction pipe to click
into place in the mounting for the blower pipe.
Illustration C
3. Allow the lower suction pipe to click into place in the
upper blower and suction pipe.
Illustration D
4. Install the motor casing.
Illustration E
a Pull out the motor casing locking pin as far as
possible.
b Insert the blower and suction pipe into the motor
casing.
c Insert the motor casing locking pin and check that
it is correctly seated in the holder.
d Insert the suction pipe fixing screw and tighten it
until it clicks audibly.
The safety button has tripped.
5. Install the collecting bag, see chapter Installing the
collecting bag.
6. Attach the carrying belt to the eyelet on the handle,
see chapter Hooking the carrying belt.
Installing the collecting bag
1. Install the collecting bag.
Illustration F
a Hook the tab of the collecting bag into the eyelet
on the upper blower and suction pipe.
b Pull the collecting bag on the adapter over the
connecting piece.
c Allow the adapter to click into place.
Hooking the carrying belt
1. Hook the carrying belt into the eyelet on the handle,
making sure the quick release is accessible at all
times.
Illustration G
English

Installation