Remaining Risk Factors; Assembly; Preparatory Activities; Delivery Content - Zipper ZI-KSS1650 Betriebsanleitung

 Provide good stability and keep balance all times
 Avoid abnormal working postures! Make sure you stand squarely and keep balance at all times.
 Always stay focused when working. Reduce distortion sources in your working environment.
The operation of the machine when being tired, as well as under the influence of alcohol, drugs
or concentration influencing medicaments is forbidden.
 When working outdoors non-slip footwear is recommended.
 Make sure that no other person is in your work place
 Remove all loose tools before starting the work
 Do not use the machine as a leader
 Assembly the stand correct before mounting the tool.
 Make sure the tool is fixed correctly on the stand before starting the work.
 Ensure that long and heavy workpieces do not affect the stability of the stand.
 Keep your fingers clear of the hinge points while pushing the stand together.
 Handle your tools with care

10.4 Remaining risk factors

It is important to ensure that each machine has remaining risks.
In the execution of all work (even the simplest) greatest
attention is required. A safe working depends on you!
Even if the machine is used as required it is still impossible to eliminate certain residual risk factors
totally. The following hazards may arise in connection with the machine´s construction and design:
Despite of correct and proper use and maintenance there remain some residual risk factors:
 Crushing hazard to the fingers while pushing the stand together
These risk factors can be minimized through obeying all security and operation instructions, proper
machine maintenance, proficient and appropriate operation by persons with technical knowledge and
experience.
11

ASSEMBLY

11.1

Preparatory activities

11.1.1 Delivery content

Please check the product contents immediately after receipt for any eventual transport damage or
missing parts. Claims from transport damage or missing parts must be placed immediately after initial
machine receipt and unpacking before putting the machine into operation. Please understand that
later claims cannot be accepted anymore.

11.1.2 Workplace requirements

The ground has to be even, in level and hard.
Consider the safety requirements and the dimensions of the machine.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
KAPPSÄGENSTÄNDER / MITRE SAW STAND ZI-KSS1650
A first aid kit in accordance with ISO 3864 should always be readily
available for a possible accident. Initiate the violation in accordance with
the necessary first aid measures. When requesting support, provide the
following details:
1. Place of accident
3. Number of injured people
N O T I C E
Emergency procedure
2. Type of accident
4. Injury type(s)
W A R N I N G
ASSEMBLY
14