Closing The Casing; Turning On The Pbx; First Setup - Auerswald COMpact 4000 Betriebsanleitung

First Setup

Closing the Casing

Important: Before closing the casing, secure the Ethernet
cable with a cable tie to one of the straps provided for strain
relief.
Note: The connections for the first commissioning (connection
to a PC/network and, if necessary, connection of a few
terminals) must be made before the casing is closed.
Alternatively, you can prepare them by laying a connecting
cable that leads out of the housing.
Requirements:
• Cables carefully reinserted
into the cable space after
installation
1. Place the upper edge of the
cover onto the top of the
casing.
2. Press the lower edge of the
cover against the casing until it
clicks into place.

Turning on the PBX

Warning: Touching voltage-carrying conductors or telephone connections can cause
life-threatening electric shocks.
• Close the casing before you put the PBX into operation.
Requirements:
• PBX connected to earthing and casing closed
Connect the PBX to a freely accessible Schuko socket.
The Power and Status LEDs light up several seconds/minutes
in red and orange.
When the LEDs light up in green, the PBX is ready for operation.
Note: If the Power LED remains continuously lit in red, an error has occurred. Please
contact your dealer or the manufacturer directly.
First Setup
Warning: Incomplete or incorrect configuration can be hazardous to people, if for
example emergency calls cannot be performed.
• The configuration of the product is made via an integrated web server whose pages
are called via web browser. The user interface of the web server (Configuration
Manager) is available in English and German. If you are not familiar with these
40
COMpact 4000 - Instructions V06 11/2020