Fitting Procedure - Panasonic TY-WK5P1RW Anleitung Zur Anbringung

Fitting procedure

1. Assembling the wall-
hanging bracket
Lay the base upper and lower fittings  and
the bracket base left and right fittings  and
 as shown in the figure.
Fit the protrusions (tabs) of the bracket base
left and right fittings into the cutouts (2 on the
left and 2 on the right) in the base upper and
lower fittings, and secure the parts using the
four screws  for assembling the fixture.
(Tightening torque: 1.2 to 1.5 N•m)
Note
• Please hold the bracket base left and right
fittings as you work with the assembled wall
hanging bracket. Holding the base upper and
lower fittings might deform this unit.
2. Checking the strength of the
installation location
 The wall-hanging bracket weighs approximately 3.2 kg
(7.1 lbs).
Refer to the instruction manual of the plasma TV, and check
the weight of the plasma TV unit which will be fitted into the
wall-hanging bracket.
 Refer to the outline drawing of the wall-hanging bracket
shown on the right, and check the wall strength at the six
installation positions shown. If the strength at any of these
positions is lacking, provide sufficient reinforcement.
Notes
• There are five pre-drilled mounting holes at the top and another
five at the bottom of the wall-hanging bracket.
Use the spare holes provided if wood or some other material is
used for the wall and a sufficient level of mounting strength cannot
be ensured by anchoring the fixture at the six positions shown on
the right.
However, bear in mind that, depending on which materials the
mounting surface is made of, cracks may form on the surface if the
screws are used at positions which are too close together.
• Mount or place only a plasma TV on the fixture: Do not mount or
place any other product.
• For details on the dimensions applying when the plasma TV is
mounted, refer to the outline drawing (on page 80-81).
6
Downloaded from www.Manualslib.com manuals search engine
[ Never use any other method than specified to
install.]
Base upper fitting 
Bracket base left
fitting 
Bracket base right
fitting 
Base lower fitting 
(side with the label attached)
25
(1.0)
55
(2.2)
Use the screws without fail to anchor the fixture.
Tab
Tab
Cutout (A)
M5x10 screws for
assembling the fixture 
Unit: mm (inches)
550 (21.7)
25
500 (19.7) (1.0)
440 55
(17.4) (2.2)
Wall mounting holes (at 6 points)