Panasonic TY-WK5P1RW Anleitung Zur Anbringung Seite 9

7. Anchoring the plasma TV
 Install the accessory screws for securing unit  (2) into the
mounting holes of the screws for securing unit on the sides
(left and right) of the wall-hanging bracket.
 Securely tighten the left and right red-marked screws  (one
at the left and one at the right) used to anchor and release the
plasma TV in the red-marked screw mounting holes on the side
of the wall-hanging bracket used to anchor and release the
plasma TV.
(Tightening torque: 1.2 to 1.5 N•m)
Note
• In order to prevent the plasma TV from becoming disengaged from the
wall-hanging bracket, the screws for securing unit  must be securely
tightened at the left and right as far as their bases.
How to remove the plasma TV from the
wall-hanging bracket
 Remove the screws for securing unit for the display  (one at the
left and one at the right) which are mounted on the sides of the wall-
hanging bracket.
 Disconnect the wires connecting the plasma TV to the other units.
 While lifting the bottom part of the plasma TV, pull the plasma TV
toward you.
 Once the insulation spacers at the bottom have been released, lift
the plasma TV straight up.
Downloaded from www.Manualslib.com manuals search engine
Red-marked screw  used to anchor
and release the plasma TV
Screw for securing unit 
Hole for mounting the screw
for securing unit
Mounting hole for red-marked
screw used to anchor and
release the plasma TV
Wall-hanging bracket
Screw for securing unit 

Insulation spacer at the

bottom
9