Hdmi Control - Sony FWD-S46H2 Bedienungsanleitung

Menu
Network Port
RS-232C
LAN
IP Address Setup
Speed Setup
Power On Delay

HDMI Control

HDMI Control
Auto Device Off
Auto Display On
Information
All Reset
34
GB
Function and operation
Sets which terminal connects to the PC when the display is remote controlled by the
PC.
Notes
• You cannot use REMOTE (STRAIGHT) and REMOTE (
• Select "LAN" when performing "IP Address Setup" or "Speed Setup".
Select when connecting the display and PC via the REMOTE (STRAIGHT)
connector.
Select when connecting the display and PC via the REMOTE (
Sets an IP address to enable communication between the REMOTE (
of the display and a device such as a PC connected with a LAN cable.
For details on how to make the settings, see the section of "Preparations for Using
the Network Functions" (page 35).
Sets a communication speed between the REMOTE (
and a device such as a PC connected with a LAN cable.
For details on how to make the settings, see the section of "Preparations for Using
the Network Functions" (page 35).
Adjusts the time from when the display is switched on until it actually turns on. Sets
to "Off", and 1 to 120 seconds. This suppresses a sudden load fluctuation to the
power equipment when multiple units are connected.
If you connect HDMI control compatible equipment to the HDMI input connector
of the display, then the equipment can be controlled together.
Note
You should use the remote control to switch on/off the display and connected
equipment.
Select "On" or "Off". If you select "On", then HDMI equipment control works, and
it can be set to "Auto Device Off" and "Auto Display On".
Notes
• If it does not work, also set HDMI settings on the connected equipment.
• To control it, the connected equipment must be HDMI control compatible, and
it must be set to enable HDMI equipment control.
• Depending on the HDMI equipment, this may not operate together with this
device in some cases.
Select "On" or "Off". If you select "On", then when the display's power is switched
off, the connected HDMI equipment's power is also switched off together.
Select "On" or "Off". If you select "On", then when connected HDMI equipment
play or other control is selected, the display's power also turns on together.
Displays the "Date", "Model Name", "Serial Number", "Operation Time",
"Software Version" and "IP Address" of your display.
Select "Cancel" or "OK". If you select "OK", then all adjustments and settings reset
to defaults.
Note
Some items of the "Information" option and the "Index Number" will not be reset.
) simultaneously.
) connector.
) connector
) connector of the display