Sony FWD-S46H2 Bedienungsanleitung Seite 63

Parts
qj DVI
(DVI-D 24-pin)
qk REMOTE (STRAIGHT)
(D-sub 9-pin)
ql REMOTE ( )
(10BASE-T/100BASE-TX)
Description
DVI IN: Connects to the digital signal output terminal of the video equipment or PC.
Supports HDCP copy protection.
Connects to the digital DVI input of a piece of video equipment or PC. Signals input from
the DVI IN connector above will be output.
DVI OUT: Connects to the digital DVI input of a piece of video equipment or PC. Signals
input from the DVI IN connector above will be output.
AUDIO IN: Inputs an audio signal. Connects to the audio signal output of a piece of
video equipment, etc.
Note
When the display is in standby mode or switched off, no signal is output from DVI OUT.
This connector enables remote control of the display using the RS-232C protocol. For
details, contact your authorized Sony dealer.
Note
When using this connector, select "RS-232C" in "Network Port". (page 34)
Serves to connect the display to a network, using a 10BASE-T/100BASE-TX LAN cable.
You can assign various settings and control the display via the network from a PC.
Caution
For safety, do not connect the connector for peripheral device wiring that might have
excessive voltage to this port. Follow the instructions for this port.
Note
When using this connector, select "LAN" in "Network Port". (page 34)
GB
15
GB