How To Adjust The Running Belt - AsViva T18 Benutzerhandbuch

MAINTENANCE AND CARE
Proper maintenance is the only way to keep your treadmill at its best.
Wrong maintenance can hurt or shorten the life of it.
Please note:
Do not use sandpaper or solvents to clean the treadmill. The controller part of the treadmill
should not be exposed directly to the sun or moisture to avoid damage. Please check and tighten
all parts of the treadmill frequently. Damaged parts must be replaced immediately.
Adjust the running belt
Adjusting the running belt has two functions: the adjustment of the tightness and the adjustment of the
center position of the running belt.
The running belt has been adjusted at the factory. However, after use, the running belt will be stret-
ched, which will deviate from the center plate and cause the running belt to rub the decorative strip and
the rear cover to damage the running belt. It is normal for the running belt to be stretched during use.
If you are using a treadmill and the running belt is slippery or not smooth, you can adjust the tightness
of the running belt to improve.

How to adjust the running belt

1. Insert the 6 mm inner hexagonal wrench into the adjusting screw on the left side of the running belt
and rotate the wrench clockwise for 1/4 turns to adjust the rear roller to tighten the running belt.
2. Repeat step 1 to adjust the right screw. It must be determined that the adjustment screw rotates the
same distance so that the rear roller is adjusted parallel to the frame.
Repeat steps 1 and 2 until the running belt does not slip.
Please note:
The running belt can't be adjusted too tightly, which will break the running belt and increase the pres-
sure of the front and rear rollers, causing problems such as roller bearing damage and abnormal noise.
If you want to reduce the tension of the running belt, turn the wrench counterclockwise. Note that the
left and right sides are rotated to the same distance.
76