Carbon Filters; Replacing Of The Illuminant - Pkm TI-60 A++IXEZ Bedienungsanleitung

6.2 Carbon filters

WARNING! Switch off the appliance and disconnect it from the mains
before you install any carbon filters (use the relevant fuse in your
household fuse box).
C
ARBON FILTERS
❖ Conventional carbon filters cannot be cleaned.
❖ The capacity of these filters is limited. You can use such filters for about 3 - 6
months approx.
❖ Replace used filters immediately. Find further information on the filter packaging.
R
➢ At least every 3 - 6 months according to the frequency of use of the extractor
hood.
➢ Type name of the

6.3 Replacing of the illuminant

WARNING! Switch off the appliance and disconnect it from the mains
before you replace the illuminant (use the relevant fuse in your household
fuse box).
NOTICE! Do not touch the illuminant with your hands. The sweat on your
fingers will reduce the operating time of your new illuminant. Use a thin
cloth or a thin glove.
1. The illuminant should have cooled down before you remove it.
2. Open the extractor flap and remove the grease filter. Release the screw of the
holder of the LED lamp on the right and left side and unplug it.
3. Take the new LED lamp (available in our accessories shop "Zubehörshop" on
https://pkm-online.net/
connector back in and fix with both screws. Put the grease filter back and close
the flap.
for your extractor hood are optional available.
EPLACEMENT INTERVAL FOR CARBON FILTERS
You can order the
www.pkm-online.de
CARBON FILTERS
or order it by phone +49 (0) 2841/ 178738) plug the
CARBON FILTERS
: See chapter T
~ ~
57
at
ECHNICAL DATA