Makita 4112HS Betriebsanleitung Seite 4

ENGLISH
(Original instructions)
1 Wing bolt
2 Base
3 Cutting depth
4 Clamping nut
5 Wheel guard
6 Switch trigger
7 Lock lever
8 Shaft lock
9 Socket wrench
SPECIFICATIONS
Max. wheel thickness
Max cutting capacity
Rated speed (n)/No load speed (n
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for cutting tracks in concrete walls or
cutting in ferrous materials or concrete drainage chan-
nels with a diamond wheel but without using water.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
General Power Tool Safety Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future refer-
ence.
4
Downloaded from www.Manualslib.com
Explanation of general view
10 Flange
11 Ring
12 Wheel
13 Flange
14 Hex bolt
15 Notch
16 Cutting line
17 Commutator
18 Insulating tip
Model
Wheel diameter
)
0
Overall length
Net weight
Safety class
manuals search engine
4112S
305 mm
3.5 mm
100 mm
–1
3,800 (min ) 5,000 (min
648 mm
11.4 kg
ANGLE CUTTER SAFETY WARNINGS
1. The guard provided with the tool must be
securely attached to the power tool and posi-
tioned for maximum safety, so the least amount
ENE026-1
of wheel is exposed towards the operator. Posi-
tion yourself and bystanders away from the
plane of the rotating wheel. The guard helps to
protect operator from broken wheel fragments and
accidental contact with wheel.
ENF002-2 2. Use only bonded reinforced or diamond cut-off
wheels for your power tool. Just because an
accessory can be attached to your power tool, it
does not assure safe operation.
3. The rated speed of the accessory must be at
least equal to the maximum speed marked on
the power tool. Accessories running faster than
their rated speed can break and fly apart.
GEA010-1
4. Wheels must be used only for recommended
applications. For example: do not grind with the
side of cut-off wheel. Abrasive cut-off wheels are
intended for peripheral grinding, side forces applied
to these wheels may cause them to shatter.
5. Always use undamaged wheel flanges that are of
correct diameter for your selected wheel. Proper
wheel flanges support the wheel thus reducing the
possibility of wheel breakage.
6. Do not use worn down reinforced wheels from
larger power tools. Wheels intended for a larger
power tool are not suitable for the higher speed of a
smaller tool and may burst.
7. The outside diameter and the thickness of your
accessory must be within the capacity rating of
your power tool. Incorrectly sized accessories can-
not be adequately guarded or controlled.
19 Carbon brush
20 Dust cover
21 Screwdriver
22 Brush holder cap
23 Dust nozzle
24 Elbow joint
25 Hose
4112HS 4114S
355 mm
3.5 mm 3.5 mm
125 mm
–1
) 3,800 (min
675 mm
12.8 kg
/II
–1
)
GEB042-5