Waeco COOLMATIC CR-Serie Bedienungsanleitung Seite 49

_cr-kuehlschraenke.book Seite 49 Montag, 6. April 2009 1:03 13
COOLMATIC CR Series
11
d
M
12
The significance of the red LED (fig. 6 2, page 5)
For operational faults it illuminates several times. The number of pulses de-
pends on the type of fault.
Each flash lasts for one quarter of a second. After the series of impulses a
pause follows. The sequence for the fault is repeated every four seconds.
Number of
flashes
1
2
3
4
5
Downloaded from www.Manualslib.com
Disposal
Danger – Risk of child entrapment!
Before you throw away your old refrigerator:
– Take off doors
– Leave the shelves in place so that the children may not easily
climb inside
Place the packaging material in the appropriate recycling waste bins
wherever possible.
If you wish to finally dispose of the device, ask your local recycling
centre or specialist dealer for details about how to do this in
accordance with the applicable disposal regulations.
Troubleshooting
Fault
Supply voltage
Excessive fan current
The motor doesn't start
Speed too low
Overheating of the electron-
ics unit
manuals search engine
Possible cause
The supply voltage is outside of the set
range.
The fan loads the electronics unit with
more than 1 A.
The rotor is jammed.
The pressure difference in the cooling
system is too high (> 5 bar).
If the cooling system is overloaded, the
minimum speed of the motor of 1850
RPM cannot be maintained.
If the cooling system is loaded too heav-
ily or the temperature is set too high, the
electronics can overheat.
Disposal
49