Clatronic AR 815 USB Bedienungsanleitung, Garantie Seite 70

Installation in ISO Slot
C
B
A
‹
Remove sleeve (D) and frame (B) from the unit. Use installa-
tion keys (C), if necessary.
‹
Place the sleeve in the ISO slot.
‹
Bend the claws outward with a screwdriver for perfect fit.
‹
Check the sleeve for tight fit.
‹
Connect the ISO female connectors of the unit with the two
ISO male connectors of the vehicle.
‹
Connect the antenna to the antenna connector at the rear of
the unit.
‹
Secure the unit against theft, if necessary. Attach bolt and
mounting strip with the fastening materials at the firewall.
70
Downloaded from www.Manualslib.com
D
C
manuals search engine
‹
Carefully slide the unit into the sleeve until it locks into place.
‹
RESET (4) with a pen or other pointed object after all
Press
connections are made.
‹
Attach the front panel (A) as described under "Attach Front
Panel".
CAUTION
Cable damage possible!
►
To avoid ca ble damage observe the cables when sliding the
unit into the sleeve.
‹
Attach the frame.
Remove Unit
Follow these instructions to remove the unit:
‹
Remove the frame.
‹
Insert left and right installation keys in the slots left and right
(the claws are now bent back).
‹
Slide the unit out of the sleeve.
NOTE
►
Unevenness of the casing can cause the claws to lock.
Unlock the claws with the installation keys, if necessary.
Toyota or Nissan Installation
NOTE
►
Sleeve, frame and mounting strip are not needed.