Use Of The Stove; Lighting Guide; Structuring The Fire; Lighting - TermaTech TT80 Serie Montage- Und Bedienungsanleitung

bly and environmentally friendly if there is sufficient airflow for combustion.

3.6. Use of the stove

Below is the procedure used for testing/approval of the stove.
It is this procedure that will lead to the best combustion for the given chimney.
The amount of firewood and the damper setting can be adjusted to the individual need for
heating and the draught in the particular chimney.
Your new TT80 has an air regulator (Air control handle) that is located under the door, in the
middle of the stove.
When the air control handle is positioned all to the right(when looking at the front of the stove),
the stove is set for ignition air supply. This setting is also called Startup air(Primary air). This set-
ting may only be used during the ignition of the stove, and for max. 10 minutes.
As soon as the stove is warmed up(latest after 10 minutes) the Air control handle must be moved
to the position of normal use(Secondary air). This is from the left side to the center position.
Place the air control handle in the center position until the fire is stabile and enough heat is gene-
rated by the stove.
Depending on the temperature in the fire, the amount of wood, the draft in your chimney and the
air supply to the stove, you are now able to find a setting of the air regulator (Air control handle),
that matches your desires, and also secures a good usage of the wood. The more air is supplied
to the stove, the cleaner it will burn and the usage of the wood is optimized.
Air control handle placed to the left, looking at the front of the stove, means that the air supply is
closed. This position may only be used when the stove is out of use, and cold.
Air control handle placed in the middle means maximum air supply. This setting secures enough
air to the burning fire.

3.7. Lighting guide

3.7.1 Structuring the fire

The fire is built by using approx. 1.5 kg kindling sticks in the middle of the burning chamber.
Place 2 firelighters on top of the fire. Kindling sticks, see section 5.1.
Start-up air (primary air) open / on maximum (push air control handle to the right).
We recommend using TermaTechs Bio firelighters (item number. 43-630), which is the natural
choice.
The bio firelighter has a long burning power and will quickly provide large flames and high tempe-
ratures.

3.7.2. Lighting

Place 2-3 bio firelighters on top of the kindling sticks. Light with a lighter or matches.
To ensure clean combustion always light the fire from the top.

3.7.3. Leave the door ajar

When the fire is lit leave the door ajar approx. 1 cm. This can be done by using the small spacer
on top of the door for the TT80. Leave the door ajar for about 5 - 10 minutes until the stove is
hot.
Incidents
• Smoke comes out when the door is ajar
33