Refilling Water; Turning Off The Appliance - Kärcher SC 1202 Kurzanleitung

Adjusting the Steam Quantity
Use the steam switch (C4) to regulate
the discharged steam.
The lock also (C3)
–> Switch in front position: no steam
(child control)
–> Switch in middle position: reduced
steam amount
–> Switch in back position: maximum
steam amount
Park the accessories
If you interrupt your work for a short period of
time, the extension tube with the floor nozzle
can be put into the parking position (see Fig.
7).

Refilling Water

The steam pressure will sink if the boiler is
empty. Then the red control light will indicate
low water (B1).
To immediately refill water, the remaining
steam pressure can be discharged quickly
while the control light indicates low water.
Note: The safety lock (A5) cannot be
opened as long as slight pressure remains in
the boiler.
Push the steam lever (C4) until steam
discharge stops. Now, the boiler of the
appliance is unpressurized.
DANGER
A residual amount of steam may be emitted
when you open the safety lock. Be careful
when opening the safety lock, there is a risk
of scalding.
22 English
Remove the safety cap (A5) from the de-
vice.
Press the ON/OFFswitch to turn off the
appliance.
DANGER
If the boiler is hot, there is the risk of scalding
as the water may splash back during the fill-
ing process! Do not fill any detergents or oth-
er additives into the boiler!
Fill the boiler with a maximum of 1.6 liters
of fresh tap water.
Screw the safety cap (A5) back onto the
device.
Press the ON/OFFswitch to turn on the
appliance.
The orange indicator lamp (B3) goes out
after approximately 10 minutes. The
steam cleaner is ready to use.

Turning Off the Appliance

Press the ON/OFFswitch to turn off the
appliance.
Disconnect the mains plug from the
socket.
Press the cover of the appliance connec-
tor (A1) to the bottom and disconnect the
Figure 7
steam plug (C6) from the appliance con-
nector.