Scope Of Supply; Requirements - Rittal Blue e+ Montageanleitung

Rittal air duct Blue e+
3

Scope of supply

Qty. Parts
1 IT air duct for wall-mounted cooling unit SK 3312.810
1 Angle bracket, rear
1 Grille for air duct
1 Air duct, vertical, preconfigured
1 Air duct, horizontal, preconfigured
1 Dispatch bag, air duct
1 Seal (W10 x H10 x L2000 mm)
2 Seal (W21 x H3 x L2000 mm)
1 Seal (W10 x H4 x L1000 mm)
8 Washer NZ/5.5
8 Pan-head screw I14583/5X16/TX25
8 482.6 mm (19") fastener, 1 U (M5)
4 Screw M5x12 self-tapping NZ/TX30
4 Split rivet 4.0x9.0
1 Insulating tape, black, self-adhesive 15M (1 m)
6 Nut D985/M5/SKT
6 Contact washer NZ/5.1, serrated
1 Assembly instructions
Tab. 1: Supply scope of an air duct
4

Requirements

Before installing the air duct, a number of requirements must be met in order to
ensure clean installation.

The site must be free from excessive dirt and moisture.

Due to the weight of the door with cooling unit, a ride-up roller should be fitted:
– Ride-up roller TS 4538.000
– Ride-up roller VX 8618.420

Install the 482.6 mm (19") mounting angles in the centre of the enclosure.
This applies to all enclosure variants (width 600 mm and 800 mm).
3 Scope of supply
EN
17