Autec C26 PRO Serie Handbuch Seite 29

13 DIAGNOSTIC
If the "radio remote control + machine" does not start, you should check if the pro-
blem is caused by the radio remote control or the machine. Before doing anything
else, therefore, connect the wired control station: if the machine does not start, the
problem is caused by the machine.
If the machine starts normally but only if activated by the wired control station, the
problem lies in the radio remote control. In this case, carry out the following controls.
Diagnostic of
transmitting
Is the green
unit
signalling LED
on flashing
slowly?
Carry out
receiving unit
diagnostic.
Diagnostic of
receiving unit
Is the POWER
Is the
ENABLE
light on?
Disconnect
the receiving unit and
open it. Are the F2-F3
fuses integral?
CALL FOR
ASSISTANCE
LIPROMU2
Insert a battery
that is charged.
Is the connection plug
between the receiving
light
unit and the machine
on?
connected correctly?
the receiving unit
and open it. Is the F1
frequency change
procedure. Does the
Replace the fuse.
Power and restart
- 29 -
Is the green
signalling LED
on flashing
quickly?
Disconnect
fuse integral?
CALL FOR
ASSISTANCE
Carry out the
machine start?
the radio
remote control.
Is the red
signalling LED on
with a steady light?
Deactivate, if active,
the actuactor
and/or the STOP
pushbutton.
If the transmitting unit
does not switch on cor-
CALL FOR
rectly,
ASSISTANCE
Correctly insert
the connection plug
and start the
radio remote control.
Replace the fuse.
Check the power
supply connections.
Power and restart
the radio
remote control.
English