Autec C26 PRO Serie Handbuch Seite 24

STOP
To immediately stop the machine, press the STOP pushbutton: the transmitting unit
switches off automatically.
To start working again, rotate the STOP button in the direction indicated and repeat
the power on and starting procedures.
The STOP circuit is approved in category 4 according to the EN 954 -1.
RPM +/-
This selector works in two ways:
1) during normal operation: increases (rpm +) or decreases (rpm -) the
machine motor turns
2) during the setting up phase REMOTE SET UP: see chapter 11
Speed
selector A speed selector may be present, which makes the machine operate at different spe-
eds as necessary. This selector can have two, three or four positions which respec-
tively activate two, three or four speed levels.
Frequency
change In case of interference or conflict with other radio systems, it is possible to change
the radio frequency being used.
With the transmitting unit powered and started, keep the START pushbutton pressed
for 5-6 seconds: a prolonged beep accompanied by the switching on of both signalling
leds indicate that the frequency has changed. During this operation the receiving unit
switches off: press the START pushbutton again to start working normally.
LED
signals
Some transmitting unit operating conditions are signalled by two signalling leds (one
green and one red):
When the battery is approximately 90% discharged, the green light will start flashing
at a faster rate to inform the operator that the battery requires recharging. If the ope-
rator continues to use the radio control, approximately 3 minutes before the battery
is fully discharged, the red light will start flashing and an acoustic alarm will sound.
In this situation, the operator must return the machine to a condition of safety (by
pressing the stop button), switch off the transmitting unit, and recharge the battery
or fit a fully charged battery.
Power off
Turn the ignition key to "O".
Always remember to extract the starting key and put it in a safe place.
The STOP pushbutton must be used each time the machine has to be
stopped immediately because of a danger situation.
Type
of signal
Slow
flashing
Quick flashing
Continuos
light during
power on *
Both lights steadily
lit simultaneously *
* accompanied by an acoustic signal
green
normal
operation
Warning
that the battery is
almost not charged
/
Frequency
changed
- 24 -
Led
red
/
Warning
that the battery
is not charged
Command
operated during
the power on
LIPROMU2