Warnings Regarding Use; Warnings Regarding Routine Maintenance - Autec C26 PRO Serie Handbuch

5

WARNINGS REGARDING USE

During
operation
In case of
danger
In case of
fault
6

WARNINGS REGARDING ROUTINE MAINTENANCE

All control and maintenance interventions carried out on the radio remote control
must be verified and recorded by the person in charge of carrying out maintenance
on the machine.
The radio remote control can only be used by operators who:
- have read and understood this manual,
- are qualified and trained,
- know the "radio remote control + machine" system well.
Autec cannot be held responsible if the radio remote control is in-
stalled on applications other than those permitted and if used in ir-
regular working conditions.
Each time the transmitting unit is powered, make sure that the
STOP pushbutton operates correctly and that, when pressed, machi-
ne movement is interrupted instantly.
If it doesn't happen, do not use the radio remote control.
The operator should always control that both units are whole and
that the gaskets, bellows and hoods of the actuators (joysticks, se-
lectors, pushbutton) are whole. If not, the radio remote control mu-
stn't be used before being repaired.
To work efficiently and to prevent possible emergency situations, it
is necessary to select a position from where it is possible to:
- remain inside the typical working range of the radio remote control
(see chapter 14)
- visibly follow the machine, its movements and a possible load at
all times.
The operator must:
- switch off the transmitting unit each time work is stopped
- NEVER leave the transmitting unit unattended with the starting
key inserted
- avoid working if the battery is almost flat.
The operator should never switch on or activate the transmitting
unit unless ready to start working. A radio link can be created even
outside the active range and from enclosed places, making the radio
remote controlled machine carry out undesired commands.
If a danger situation arises, the operator must intervent immedia-
tely by pressing the STOP button, which instantly interrupts machi-
ne movement.
As not all dangers are caused by the "radio remote control + machi-
ne" system, the operator should be careful even when emercency
situations are present in the work area. The operator should, also in
this case, intervene manually by activating the STOP command.
In case of faults or damaged parts, ALWAYS STOP the "radio remote
control + machine" system until the problem has been solved.
Any damaged part can ONLY be replaced by authorised Autec per-
sonnel and only using original Autec spare parts.
While carrying out routine and special maintenance on the radio re-
mote control and the machine, remove the battery from the tran-
smitting unit and disconnect the connection plug from the receiving
unit.
- 20 -
LIPROMU2