Transmitting Unit And How It Works - Autec C26 PRO Serie Handbuch

Warrantly
The conditions of warranty applicable to the radio remote control are specified in the
"Warranty Certificate" in the manual.
The electronic components which have a 3 year guarantee are: MTX_____,
MRX_____, RD97____, RI97____ and CH97____.
Technical
data sheet The technical data sheet shows the wiring system between the receiving unit and the
machine. It should be filled out and checked by the installer, who has the responsi-
bility of a correct wiring.
Once all necessary checks have taken place the installer must undersign the technical
data sheet, which must be kept with the user's manual (always keep a copy of this
data sheet in case it could be required).
Identification
plates The radio remote control identification data are written on a technical data plate both
on the transmitting unit and on the receiving unit.
The plates MUST NOT be removed from where they are placed or damaged.
In this case, the warranty will be forfeited.
9

TRANSMITTING UNIT AND HOW IT WORKS

L
D
C
Power on and
Check that the starting key is in position "O", insert the battery in its hou-
starting
sing without force. Check that the STOP push button has not been pressed
and that none of the actuactors have been out of neutral position.
Turn the key to "I" and activate START push button and release it when
the green light starts to flash.
Commands
It is possible to control the radio remote machine only after the transmitting unit has
been radio linked to the receiving unit (signalled by the lighting up of the ENABLE pilot
light on the receiving unit (see chapter 10)).
Activate the actuators that carry out the moves to be made.
All commands protected by the SAFETY function are approved category 3 of EN 954
- 1 against the undesired movements when in the standstill position (UMFS - Unin-
tended Movement From Standstill).
Some transmitting unit commands are given below:
Clacson
With the transmitting unit switched on, press the START pushbutton: the machine
horn/alarm activates.
LIPROMU2
A
E
H
F
The transmitting unit only switches on if the battery is charged
enough and if all the actuators are inactive.
- 23 -
A
actuators (joystick or selector)
B
STOP push button
C
START / clacson push putton
D
starting key
E
selector rpm +/-
F
speed selector
G
battery
H
identification plate
L
two signalling leds (green and red)
G
B
English