Ryobi PBV-30 Bedienungsanleitung Seite 23

GB
F D
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICING DEALER.
PROBLEM
Engine will not start
Engine starts but
will not accelerate
Engine starts but will
only run at high speed
at half choke
Engine does not reach
full speed and emits
excessive smoke
Engine starts, runs,
and accelerates but
will not idle
NOTE: The carburetor adjustment needle(s) are equipped with plastic cap(s) that prevents counterclockwise rotation
from the original factory adjustment. If your unit exhibits specific performance problem(s) where the Trouble Shooting
Section recommends a counterclockwise needle adjustment and no adjustments have been made since original
purchase, the unit should be taken to a factory authorized service dealer for repair. In most cases, the needed
adjustment is a simple task for the factory trained service representative. See Figure 13.
E I P NL
TROUBLESHOOTING
POSSIBLE CAUSE
1. No spark.
2. No fuel.
3. Flooded engine.
4. Starter rope pulls harder
now than when new.
Carburetor requires adjustment.
Carburetor requires adjustment.
1. Oil / fuel mixture is incorrect.
2. Air filter is dirty.
3. Carburetor requires
adjustment.
4. Spark arrestor screen is dirty. 4. Contact a servicing dealer.
Carburetor requires adjustment.
S DK N FIN
English
SOLUTION
1. Check spark. Remove spark plug. Reattach the spark
plug cap and lay spark plug on metal cylinder. Pull the
starter rope and watch for spark at spark plug tip. If
there is no spark, repeat test with a new spark plug.
2. Push primer bulb until bulb until fuel is visible in the
bulb. If fuel is not apparent, the primary fuel delivery
system is blocked. Contact a servicing dealer. If primer
bulb fills, engine may be flooded (see next item).
3. Remove spark plug, turn blower so spark plug hole is
aimed at the ground. Move choke lever to "RUN" and
pull starter cord 10 to 15 times. This will clear excess
fuel from engine. Clean and reinstall spark plug. Pull
starter three times with choke lever at "RUN". If engine
does not start, move choke lever to "CHOKE" and
repeat normal starting procedure. If engine still fails to
start, repeat procedure with a new spark plug.
4. Contact a servicing dealer.
Turn "L" needle (30) counterclockwise 1/16 turn.
If "L" low needle can not be turned counterclockwise, do
not force plastic limiter caps. Contact a servicing dealer.
See Figure 13.
Turn "H" needle (31) counterclockwise 1/16 turn.
If "H" high needle cannot be turned counterclockwise,
do not force plastic limiter caps. Contact a servicing
dealer. See Figure 13.
1. Use fresh fuel and the correct 2-stroke oil mix.
2. Clean air filter, refer to "Replacing and Cleaning
the Air Filter" earlier in this manual.
3. Turn "H" (B) needle clockwise 1/16 turn. See Figure 13.
Turn idle speed screw (29) clockwise to increase
idle speed. See Figure 13.
18
GR H CZ RUS RO PL