Installing And Removing Flat Panel Screen; Adjusting The Tilt Angle Of The Flat Panel Screen - PEERLESS Mounts SmartMount ST630P Anbringung Und Zusammenbau

Installing and Removing Flat Panel Screen

Attach screen to tilt assembly (B). Tighten M5 x 6
6
mm screw (H) to lock screen to tilt assembly.
Note: For security models, use security driver (I) to
tighten M5 x 6 mm screws (H).
To remove screen from mount, loosen screw (H)
and lift screen off of mount.
WARNING
• Do not lift more weight than you can handle. Use ad-
ditional man power or mechanical lifting equipment
to safely handle placement of the screen.
• Failure to lock hook plate (A) with screw (H) can
cause screen to come off mount if hit accidentally.
CAUTION
• Do not tighten screws with excessive force.
Overtightening can cause damage to mount. Tighten
screws to 20 in. • lb (2.26 N.M.) maximum torque.

Adjusting the Tilt Angle of the Flat Panel Screen

Adjust tension knob on right side of mount shown in
7
figure 7.1 to desired tension to balance your screen
size and weight.
Note: If knob is inaccessible, remove screen from
mount, adjust tension knob to desired tension to
balance your screen size and weight, and reattach
screen to mount as stated in step 6.
Push or pull from top or bottom of screen to adjust
tilt as shown in figure 7.1. The tilt can be adjusted to
a maximum of 15° forward or 5° backward.
CAUTION
• Do not tighten screws with excessive force.
Overtightening can cause damage to mount. Tighten
screws to 40 in. • lb (4.5 N.M.) maximum torque.
CAUTION
• Be careful not to pinch fingers when pushing screen
from the bottom.
SCREEN
8 of 16
All other brand and product names are trademarks or registered trademarks of their respective owners.
H
A
B
fig. 6.1
TENSION KNOB
fig. 7.1
ISSUED: 02-05-09 SHEET #: 202-9336-1
© 2009, Peerless Industries, Inc. All rights reserved.
Peerless Industries, Inc.
Melrose Park, IL 60160
www.peerlessmounts.com
3215 W. North Ave.