Search And Edit Channel; Auto Scan; Manual Channel Search; Edit Channels - AEG CTV 3202 LCD Bedienungsanleitung, Garantie

English
30
Return to Main Menu
To select a different item from the main menu first exit the active submenu.
• Repeatedly press MENU until the main menu header (e.g. CHANNEL) is highlighted.
Exit Menus
• Press the MENU utton to exit the menus step by step or press the EXIT button to exit the menu. Your changes are
saved.
NOTE:
You can adjust the duration of the super-imposed menu in the menu OPTIONS.

7. Search and Edit Channel

Your television can receive conventional, analogue signals (e.g. through cable connection). An automatic and a manual
search process are available to you.
• Analogue channels are displayed as ATV in the OSD menu.

7.1 Auto Scan

7.2 Manual Channel Search

1. Press the MENU button to display the OSD main menu.
2. Press in CHANNEL menu to select ATV Manual Tuning and press ENTER.
3. Under Storage to press / to select the position in the channel list for the new
analogue channel.
4. Press / to highlight Search.
5. Press / to start the manual scan. The changing frequency is displayed during
the scan. After a channel is found the sound is activated again.
6. Press the red button to save the channel.
7. To scan for additional channels first select a position in the channel list for the new
analogue channel with Storage To and then restart the scan.
In this menu you can also perform the following settings: System: is generally not changed. Current CH: shows which
channel is active in the background. Press / to change. Fine-Tune: Press / to change the frequency in small steps.
Frequency: Shows the current frequency.

7.3 Edit Channels

After auto scan all channels are saved in found sequence. You can add channels in the favourite list (FAV) or change the
sequence by moving or skipping channels.
1. Press the MENU button to display the OSD main menu.
2. Press in CHANNEL menu to select Auto Scan.
3. Press ENTER.
4. Then press to select the country as your location.
5. Press ENTER to start Auto Scan. This will take a few minutes. The
progress is shown on screen.
6. After auto scan channel 1 is displayed.
7. The window closes automatically after a few seconds or press EXIT
to close it.