Declaration Of Conformity / Ce Marking; Obligations Of The Operator - Bosch Rexroth WSC60GK Betriebsanleitung

56/73 Bosch Rexroth AG
Safety instructions
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
Employing unqualified personnel
Possibility of reduction of safety of persons/systems, function
disturbances/restrictions!
Make sure that repair and maintenance work is performed by our

service or corresponding authorized repair or service points only!
High dynamic forces and extremely fast movements
Danger of impacts, bruises, entanglement and burns!
You should always be aware of the possibility that motions can be

triggered by faults of the system and behave with the appropriate
care and sense of responsibility.
Always stay outside the danger area of the welding system when it

is running!
Do not ever deactivate any safety–relevant functions!

Robots and fixing elements may generate very high dynamic
forces and extremely fast movements. In addition, expulsion may
occur during a welding schedule.
Rotating fan impellers
Possibility of hand injuries!
Do not place your fingers or any objects into the fan units when the

24V logic supply of the WT is switched on.
Devices with air cooling must be operated with forced ventilation.
They are equipped with a temperature-controlled automatic switch
on/off system for the control of external fans.
2.6.8

Declaration of conformity / CE marking

For details on declaration of conformity/on the CE-mark, please refer to
chapter 16.1.
2.7

Obligations of the operator

The operator is responsible for the system.
Therefore he has to
• ensure that the system is operated according to its intended use,
• provide regular training to the operating personnel,
• provide signals of existing dangers that are clearly visible and unambiguous
to all persons,
• comply with the safety regulations and provisions of the country
R911345359 | WSC60GK/HA/ST
WARNING
WARNING