Operating The Product - Bosch Rexroth WSC60GK Betriebsanleitung

54/73 Bosch Rexroth AG
Safety instructions
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
2.6.5

Operating the product

Strong electromagnetic fields during the welding sequence
Possibility of function disturbances of cardiac pacemakers, other
implants or also hearing aids!
Make sure that persons dependent on or using devices of this kind

generally avoid resistance welding equipment.
Make sure that corresponding warning signs are posted at a

proper distance from resistance welding equipment.
Please observe EC directive „Electromagnetic fields

(2004/40/EC)". It defines the limit values for extremities which
may be exceeded especially in manual welding gun applications.
In cases of doubt, please measure the field strength and provide
additional measures to ensure health and safety at work.
Please note the Instructions BGV B11, "Accident prevention regulation

relating to electromagnetic fields" issued by the Berufsgenossenschaft
(employers' third party liability insurance association).
High dynamic forces and extremely fast movements
Danger of impacts, bruises, entanglement and burns!
You should always be aware of the possibility that motions can be

triggered by faults of the system and behave with the appropriate
care and sense of responsibility.
Do not ever deactivate any safety–relevant functions!

Always stay outside the danger area of the welding system when it

is running!
Make sure that moving system elements are halted safely before

accessing the danger area of the system!
Robots and fixing elements may generate very high dynamic
forces and extremely fast movements. In addition, expulsion may
occur during a welding schedule.
Fault reset
Dangerous machine movements possible!
Prior to acknowledging error messages, make sure that there is

no-one in the hazard area of the welding equipment!
If the start signal is present when an error message is acknowledged,
the weld timer will start its program run immediately.
Damaged system parts
Possibility of reduction of safety of persons/systems, function
disturbances/restrictions!
Before starting to work, subject the plant to a reasonable, practical

check for possible damages (e.g. visual inspection).
Report any damages and malfunctions of the unit to your supervisor

and servicing or repair department immediately.
R911345359 | WSC60GK/HA/ST
WARNING
WARNING