Installation And Assembly - Bosch Rexroth WSC60GK Betriebsanleitung

58/73 Bosch Rexroth AG
General notes for property damages and product damages
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
3.2

Installation and assembly

Metal burrs from drilling and sawing work
Possibility of short-circuits, damage to electrical equipment, unexpected
plant reactions!
All affected components in the switch cabinet should be well partitioned

prior to all work!
Non-compliance will result in the extinction of any warranty claims.

Remove all metal burrs carefully after work.

Water leakage while connecting cooling water lines
Possibility of damage to the electrical equipment, unexpected
plant reactions!
All affected components in the switch cabinet should be well partitioned

prior to all work!
Non-compliance will result in the extinction of any warranty claims.
Remove residual moisture carefully after work.

Leakage in the cooling fluid circuit
Possibility of damage to the electrical equipment, unexpected
plant reactions!
Install the water-cooled modules so that the units inside the switch

cabinet are sufficiently protected against leaking cooling water.
Heat accumulation caused by insufficient clearance
Possibility of temporary interruption of the welding process, a reduced
useful life of the product, destruction of the device, damage
to the electrical equipment, unexpected plant reactions!
Make sure that an installation clearance of at least 100 mm remains

above or below the ventilation slots of the product.
R911345359 | WSC60GK/HA/ST
NOTICE