T+A DVD 820 M Betriebsanleitung Seite 75

Problem:
Cause:
Remedy:
Problem:
Cause:
Remedy:
Problem:
Cause:
Remedy:
Problem:
Cause 1:
Remedy:
Cause 2:
Remedy:
Cause 3:
Remedy:
Problem:
Cause 1:
Cause 2:
Remedy:
Problem:
Cause:
Remedy:
Downloaded from www.Manualslib.com
Black and white picture, distortion or
scrolling when playing a DVD or VCD.
The television is not set to the same
picture name (PAL / NTSC) as the disc, or
cannot process its picture norm.
Use a multi-norm TV set. These sets
automatically switch to the current picture
norm, or can be switched over manually.
Distorted TV picture.
Incorrect or damaged video lead.
Use correct lead in good condition.
After removing the disc the machine
fails to return to the Start screen.
The program may be waiting for a further
disc.
Insert the next disc.
The picture is displayed too small or
incompletely (abbreviated).
The DVD in the drawer is not set to the
same picture format (4 : 3 or 16 : 9) as the
TV set connected to the system.
Set the correct picture format in the DVD's
disc menu.
Many DVDs contain film recordings in
different picture formats on the front and
rear faces.
Turn DVD over and start again.
The television is set to the wrong picture
format.
Set the TV to the correct picture format,
i.e. the one corresponding to the DVD.
The DVD 820 M fails to carry out certain
functions.
Function blocked for this DVD.
Function (e.g. camera angle, sub-titles
etc.) not present on this DVD.
No remedy possible.
After inserting a DVD the screen
displays a warning of the wrong
regional code.
The DVD is not approved for Europe.
Contact your DVD supplier and exchange
the disc for a version approved for Europe.
manuals search engine
Problem: The DVD will not start playing; the
screen displays a request to enter the
PIN.
Cause:
The child-lock is active.
Remedy:
Enter the release code. Alternatively:
authorise the DVD, or switch off the child-
lock (see 'Child security').
Problem: Scrolling picture or incorrect colours.
Cause: TV set is connected to the component
video output, and the wrong signal type
(RGB/YUV) is set.
Remedy: Set the correct signal type (RGB/YUV)
(see section 'Basic device settings,
video output') and move the slide switch
on the rear panel to the correct setting for
the video mode.
Problem: MP3 CD does not play back.
Cause:
MP3 format not supported
(see 'Playing MP3 CDs').
Problem: Picture is distorted, or has a greenish
cast.
Cause: Different colour
DVD 1230 R and the display device.
Remedy: Select the Setup menu and set the
appropriate colour norm (RGB or YUV).
75
norms set on the