T+A DVD 820 M Betriebsanleitung Seite 56

PROGRESSIVE
The 'Progressive' menu point can only be altered if you
have set the Component output to 'YUV' (see menu point
'Component').
In progressive scan mode the machine generates full-
frame images from the 'half-frames' stored on the DVD;
this reduces picture flicker, and therefore gives improved
picture reproduction with monitors and TV screens which
are capable
Progressive pictures are generated in the form of a YUV
component signal, so the DVD 820 M must be connected
to the YUV input of your monitor or screen in order to be
able to use progressive scan.
Important note:
Before you activate progressive scan, please ensure that
your video monitor or television set supports this mode of
operation (read the operating instructions if you are not
sure)!
If the monitor is not designed for progressive scan, the
result will be picture interference, or even no picture at
all. If a problem arises, please switch back to normal
operation immediately.
Off
Disables the progressive scan function.
On
Activates the progressive scan function.
PICTURE SETTING
In the Picture Setting menu you can adjust the picture
reproduction to suit your personal preference.
You can either select one of the pre-defined picture
settings, or move to the menu point 'Personal' and set
your preferred settings for brightness, contrast etc.
Downloaded from www.Manualslib.com
of reproducing progressive
manuals search engine
COMPONENT
This menu point enables you to toggle the Direct Video
Monitor output of the video signal between RGB and
YPbPr (YUV).
For this the switch on the back panel must be set to the
bottom position (YUV / RGB / CVBS). The upper switch
position is intended for S-Video (Y/C) (see the chapter
entitled 'Connections').
images.
56