Appropriate Use; Transport And Storage - Bosch REXROTH IndraDrive HCS03 Sicherheits- Und Gebrauchshinweise

2 Drive Components
Signal Words of the Safety Instructions
The signal words of the safety instructions in this documen-
tation have the following significances:
WARNING
In case of non-compliance with a safety instruction contain-
ing the signal word "WARNING", death or serious injury
could occur.
CAUTION
In case of non-compliance with a safety instruction contain-
ing the signal word "CAUTION", minor or moderate injury
could occur.
General Safety Instructions and Directions for Use
WARNING
Danger to life in case of non-compliance with the below-
mentioned safety instructions!
Serious personal injury in the case of improper conduct!
▶ Do not attempt to put the drive components into opera-
tion until you have read and observed the safety instruc-
tions.
▶ Only qualified staff or competent persons are allowed to
mount, electrically connect and commission the drive
components. A competent person knows the relevant
standards and regulations. A competent person must be
able to judge the delegated work and identify potential
hazards.
▶ Observe all instructions to be found on the drive compo-
nents and in the Operating Instructions, as well as the
standards and regulations applicable to your drive sys-
tem.
The drive components can cause hazards.
Protect yourself from the following hazards:
▶ Improper transport and mounting
▶ Magnetic and electromagnetic fields
▶ Electrical voltage
▶ High temperatures of the drive components
▶ Improper handling of batteries
Bosch Rexroth AG, Edition 02, R911339259, DOK-DRIVE*-SAFETY*****-SA02-EN-P
If you do not understand an instruction in this documenta-
tion or in the Operating Instructions, or if you have any
questions, please contact the Rexroth service, before you
start working (tel.: +49 9352 405060, e‑mail:
service.svc@boschrexroth.de
www.boschrexroth.com/electrics).

Appropriate Use

Drive components made by Rexroth are designed to control
electrical motors and monitor their operation.
It is the prerequisite for the intended use and the safe han-
dling of the drive components that you proceed appropri-
ately and correctly in the case of the following activities:
▶ Transport
▶ Storage
▶ Mounting
▶ Installation (electrical connection system)
▶ Commissioning
▶ Operation
▶ Dismounting
▶ Disposal
The drive components are exclusively designed for commer-
cial and industrial use. Only operate the drive components
under the specified conditions (see index entries "Data",
"Dimensions", "Instructions for use" and "EMC" in the Ope-
rating Instructions). Using drive components in potentially
explosive areas is forbidden.

Transport and Storage

WARNING
Risk of injury during transport by improper handling!
▶ Only use suitable and sufficiently sized lifting gear and
means of transport.
▶ Secure eyebolts before using them and check them for
tight fit.
▶ Never be under hanging loads.
▶ Use suitable personal protective equipment (e.g. safety
shoes).
Store the drive components in their original packages, in a
dry, dust-free, vibration-free place, and protect them from
light and direct solar radiation.
or