Automatic Switch-Off - AEG BP8615101 Benutzerinformation

18 www.aeg.com
1. Activate the appliance.
2. Touch
To deactivate the Child Lock function
repeat step 2.
10.3 Function Lock
This function prevents an accidental
change of the heating function. You can
activate it only when the appliance
operates.
1. Activate the appliance.
2. Set a heating function or setting.
3. Press
4. Press
To deactivate the function, press
display shows a message. Press
and then
10.4 Set + Go
The function lets you set a heating
function (or a programme) and use it
later with one press of a sensor field.
1. Activate the appliance.
2. Set a heating function.
3. Press
4. Set the time.
5. Press
6. Press
Downloaded from www.Manualslib.com
If the Pyrolysis function
operates, the door locks
automatically.
A message comes on in the
display when you touch a
sensor field.
and at the same time
until the display shows a message.
again and again until the
display shows: Function Lock.
to confirm.
If the Pyrolysis function
operates, the door is locked
and the symbol of a key
comes on in the display.
to confirm.
When you deactivate the
appliance, the function also
deactivates.
again and again until the
display shows: Duration.
again and again until the
display shows: Set + Go.
to confirm.
manuals search engine
Press a sensor field (except for
start the function: Set + Go. The set
heating function starts.
When the heating function ends, an
acoustic signal sounds.
• Function Lock is on when
the heating function
operates.
• The menu: Basic Settings
lets you activate and
deactivate the function:
Set + Go.

10.5 Automatic Switch-off

For safety reasons the appliance
deactivates automatically after some
time if a heating function operates and
you do not change any settings.
Temperature (°C)
30 - 115
120 - 195
200 - 245
250 - maximum
. The
The Automatic switch-off
again does not work with the
functions: Light, core
temperature sensor, End
Time, Duration.
10.6 Brightness of the display
There are two modes of display
brightness:
• Night brightness - when the appliance
is deactivated, the brightness of the
display is lower between 10 PM and 6
AM.
• Day brightness:
– when the appliance is activated.
– if you touch a sensor field during
the night brightness (apart from
ON / OFF), the display goes back
to the day brightness mode for
the next 10 seconds.
– if the appliance is deactivated and
you set the function: Minute
Minder. When the function ends,
) to
Switch-off time (h)
12.5
8.5
5.5
1.5