Ottobock 50R301N Dyneva light Gebrauchsanweisung Seite 14

4) Tighten the screw.
Optional: Horizontally adjusting the back pads
1) INFORMATION: The back pads can be inserted in one of the three holes for horizontal
positioning. Install all cover caps after positioning (see fig. 3).
2) Remove the back pad cover caps.
3) Loosen the back pads from the brace frame.
4) Insert the back pads into one of the three holes.
5) Reinstall the cover caps.
Optional: Replacing the lower tube frame
1) INFORMATION: Optimize the fit of the lower tube frame by replacing the tube frame.
The replacement size may only be one size smaller or bigger (reference number
29R414=XS/S/M/L/XL/XXL).
2) Loosen the screws on the lower tube frame.
3) Replace the tube frame.
4) Tighten the screws.
Optional: Attaching lateral pads to the tube frame
2x
29R390
2x
1) To improve wearer comfort, attach and adapt the lateral pads, which can be ordered sepa­
rately, to the ends of the tube frames. One set of side pads (29R390) is required for the upper
and lower tube frames.
2) Loosen the screws of the cover for the upper tube frame.
3) Take off the tube frame.
4) Slide the lateral pads onto the tube frame.
5) Insert the tube frame into the spring adapters and tighten the screws.
5.3 Application
CAUTION
Direct skin contact with the product
Skin irritation due to chafing or sweat formation
Do not wear this product directly on the skin.
►
14