Hach KUNBUS-GW PROFINET TPS-1 Bedienungsanleitung Seite 24

Message
Run LED is off.
Run LED flashes green.
Run LED flashes slowly
green.
Diag LED flashes red.
Diag LED flashes fast red. No connection to the controller. No
Diag LED is red.
L/A 1 or 2 LED is off.
L/A 1 or 2 LED flashes
green.
24 English
Description
No connection to a network.
Profinet controller is connected but
no data exchange.
Triggered by tool for identification
of the gateway component.
Triggered by tool for identification
of the gateway component.
Profinet name set in the module.
A Gateway device reports
diagnosis data.
No connection to a network.
Data exchange.
Solution
Connect to network.
Wait until the next data
exchange.
Wait a few minutes.
Wait a few minutes.
Refer to Configure the Profinet
Gateway on page 18 to set the
name.
Refer to the diagnostic report.
Connect to network.
Wait until the data exchange is
complete.