Hach KUNBUS-GW PROFINET TPS-1 Bedienungsanleitung Seite 22

9.2 Troubleshooting Ethernet/IP
Figure 5 Ethernet/IP Gateway
Message
Power LED is off.
Power LED flashes
green.
Power LED flashes red.
Power LED is red.
MS LED is off.
MS LED flashes green.
MS LED flashes red.
MS LED is red.
MS LED flashes red and
green.
22 English
Description
The Ethernet/IP gateway is set to
off.
The start up procedure is not
complete.
Shows a warning.
Shows an error.
The Ethernet/IP gateway is set to
off.
The configuration procedure is not
complete.
Shows a configuration error.
Shows an error.
The self test is not complete.
Solution
Set the power to on.
Wait a few minutes.
Examine if all of the devices are
connected.
The Ethernet/IP gateway is
defective. Replace the Ethernet/IP
gateway.
Set power to on.
Wait a few minutes.
Refer to Configure the Ethernet/IP
Gateway on page 15 to examine
the configuration.
The Ethernet/IP gateway is
defective. Replace the Ethernet/IP
gateway.
Wait a few minutes.