PeakTech 2170 Bedienungsanleitung Seite 57

7.8. Equivalent Circuit
1. When any L/C/R functional mode is selected, the default
measurement in series or parallel mode is auto selected
and the AUTO segment will be shown on LCD display. It
depends on the total equivalent impedance measured.
2. If the impedance is larger than 10kΩ, parallel mode is set
and Lp/Cp/Rp is shown on the display.
3. If it is less than 10kΩ, series mode is set and Ls/Cs/Rs is
shown on the display.
4. When SEL/PAL
measurement will be set in series mode or in parallel mode
sequentially.
Note:
The actual capacitance, inductance and resistance is not ideal
component of pure reactance and pure resistance. Usually the
resistance and reactance exist simultaneously. A practical
impedance can be simulate by the ideal resistors and ideal
reactor (inductor or capacitor) in series or parallel form.
7.9. Sorting mode
The sorting mode could help the user to make a quick sort for
a bunch of components. Use the setting steps as following:
1. According to the component type, press FUNC. key to
select L, C or R measurement mode.
2. Insert the standard component into the input terminal.
Press SORTING key to enter into the sorting mode and the
"Sorting" symbol appears on LCD. If the LCD reading is OL
or less than 200 counts, the SORTING key is not available.
3. When sorting mode is active, press SETUP key to modify
the range, reference value and the tolerance settings
sequentially.
key is pressed,
-56-
the impedance