Maintenance; Scheduled Maintenance Table - Nilfisk-ALTO SCRUBTEC R 253 Bedienungshandbuch

ENGLISH

MAINTENANCE

The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following table provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,
which are to be defined by the person in charge of the maintenance.
WARNING!
The procedures must be performed with the machine off and the battery disconnected.
Moreover, read carefully the instructions in the Safety chapter before performing any maintenance procedure.
All scheduled or extraordinary maintenance procedures must be performed by qualified personnel, or by an authorised Service
Center.
CAUTION!
When the Service icon
scheduled maintenance.
This Manual describes only the simplest and most common maintenance procedures.
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be consulted
at any Service Center.

SCHEDULED MAINTENANCE TABLE

Procedure
Battery Charging
Squeegee Cleaning
Brush/pad cleaning
Recovery tank and debris tray cleaning, and cover gasket check
Chemical Mixing System cleaning and draining (optional)
Squeegee blade check
Solution Filter Cleaning
Battery (WET) fluid level check
Squeegee blade replacement
Electromagnetic brake efficiency check
Brush/pad-holder motor carbon brush check or replacement
Drive system motor carbon brush check or replacement
(1) This maintenance procedure must be performed by Nilfisk Alto authorised Service Center.
18
INSTRUCTIONS FOR USE
appears on the display (48), contact an authorised Nilfisk Alto Service Centre for
SCRUBTEC R 253 - 9100000391
Daily, after using
Weekly
the machine
Every six
Yearly
months
(1)
(1)
(1)
1/15