Lubrication - Heiniger Xperience 2-Speed Betriebsanleitung

NOTE!
Only work with sharp blades, replace blunt or defective blades
X X
without teeth. The correct resharpening of blades is only to do
by special machines or by a specialist. In that case, contact
your service centre.
6.6

Lubrication

Fig. 10
CAUTION!
POSSIBLE DAMAGE TO THE CLIPPER!
Insufficient oiling of the clipping head will lead to warming and will
shorten the life of the clippers and its blades.
Oil the clipping blades adequately during the clipping session,
X X
at least once every 15 minutes, so that they do not run dry.
Only use the special oil supplied or a paraffin oil conforming to
X X
the ISO VG 15 specification.
NOTE!
The provided oil is non-toxic and produces no irritation on con-
X X
tact with the skin or the mucous membranes. This paraffin oil
degrades to some 20% after 21 days (CEL-L-33-T-82).
Oil the blades prior to, during and after every use.
X X
Oil the blades no later than when the blades leave streaks or slow down.
X X
Apply several drops of oil on the front and on the sides of the clipping
X X
blades (see Fig. 10).
Wipe excess oil off with a soft, dry cloth.
X X
Lubrication sprays do not have sufficient oil for a good lubrication, but
X X
serve for cooling the blades.
Immediately replace damaged or notched blades in order to avoid inju-
X X
ries.
14
To achieve a well-clipped animal and to
increase the life of the device including
the clipping head, it is necessary to ap-
ply a thin coat of oil between the upper
and lower blades. All other moving parts
of the clipping head must also be lubri-
cated.
Apply some drops of oil on to the
X X
clipping blades and into the lubrica-
tion opening.
Instruction Manual / Xperience 2-Speed cattle clipper