Lubrication - Heiniger Xperience/C Originalbetriebsanleitung

1,5 – 2 mm
Fig. 9
NOTE!
Only work with sharp shearing blades, replace blunt or
X
defective blades without teeth. The correct resharpening of
shearing blades is only to do by special machines or by a
specialist. In that case, contact your service centre.
6.6

Lubrication

Fig. 10
CAUTION!
POSSIBLE DAMAGE TO THE SHEARING MACHINE!
Insufficient oiling of the shearing head will lead to warming and
will shorten the life of the shearing machine and its blades.
Oil the shearing blades adequately during the clipping session,
X
at least once every 15 minutes, so that they do not run dry.
Only use the special oil supplied or a paraffin oil conforming to
X
the ISO VG 15 specification.
NOTE!
The provided oil is non-toxic and produces no irritation on
X
contact with the skin or the mucous membranes. This paraffin
oil degrades to some 20% after 21 days (CEL-L-33-T-82).
14
Translation of the original instructions / Cattle clipper Xperience
Install the new lower blade. Align
X
it so that the ground surface of the
lower blade protrudes approx. 1.5 -
2 mm above the point of the upper
blade.
Tighten the comb plate screws.
X
To achieve a well-clipped animal and to
increase the life of the device including
the clipper head, it is necessary to apply
a thin coat of oil between the upper and
lower blades. All other moving parts of
the clipper head must also be lubricated.
Apply some drops of oil on to
X
the clipping blades and into the
lubrication opening.