Troubleshooting - Black+Decker BDCD18 Bersetzung Der Ursprünglichen Anweisungen

Vorschau ausblenden

Inhalt

Inhaltsverzeichnis

Verfügbare Sprachen

ENGLISH

Warning! Do not use tool while it is connected to the charger.

Warning! fire Hazard. When disconnecting the charger from

the tool, be sure to unplug the charger from the outlet first,

then disconnect the charger cord from the tool.

Installing and removing the battery pack from the

tool (fig. B)

Warning! Make certain the forward/reverse slider (2) is in the

locked position (see trigger switch & reversing button" section)

to prevent switch actuation:

Insert battery pack (4) into tool, until an audible click is

heard (fig. B)

Removing the battery pack from the tool (fig. C)

Depress the battery release button (5) as shown in (fig. C)

and pull battery pack (4) out of tool.

Operating Instructions

Trigger switch & reversing button (fig. D)

The drill is turned ON and OFF by pulling and releasing

the trigger switch (1). The farther the trigger is depressed,

the higher the speed of the drill.

A forward/reverse control button (2) determines the direc-

tion of the tool and also serves as a lock off button.

To select forward rotation, release the trigger switch and

depress the forward/reverse control button to the left.

To select reverse, depress the forward/ reverse control

button the opposite direction.

To lock the tool, set the forward/reverse slider into the

centre position.

Note! The center position of the control button locks the tool

in the off position. When changing the position of the control

button, be sure the trigger is released.

Keyless chuck (fig. E)

Warning! Make certain the forward/reverse slider (2) is in the

locked position (see trigger switch & reversing button" section)

to prevent switch actuation.

To insert a drill bit or other accessory:

Grasp the rear half of the chuck (7) with one hand and use

your other hand to rotate the front half (8) in the counter-

clockwise direction, as viewed from the chuck end.

Insert the bit or other accessory fully into the chuck, and

tighten securely by holding the rear half of the chuck and

rotating the front portion in the clockwise direction as

viewed from the chuck end.

Warning! Do not attempt to tighten drill bits (or any other ac-

cessory) by gripping the front part of the chuck and turning the

tool on. Damage to the chuck and personal injury may occur

when changing accessories.

(Original instructions)

Drilling/screwdriving

Select forward or reverse rotation using the forward/re-

verse slider (2).

To switch the tool on, press the switch (1). The tool speed

depends on how far you press the switch.

To switch the tool off, release the switch.

Hints for optimum use

Drilling

Always apply a light pressure in a straight line with the drill

bit.

Just before the drill tip breaks through the other side of the

workpiece, decrease pressure on the tool.

Use a block of wood to back up workpieces that may

splinter.

Use spade bits when drilling large diameter holes in wood.

Use HSS drill bits when drilling in metal.

Use masonry bits when drilling in soft masonry.

Use a lubricant when drilling metals other than cast iron

and brass.

Make an indentation using a centre punch at the centre of

the hole to be drilled in order to improve accuracy.

Screwdriving

Always use the correct type and size of screwdriver bit.

If screws are difficult to tighten, try applying a small

amount of washing liquid or soap as a lubricant.

Always hold the tool and screwdriver bit in a straight line

with the screw