Leister MISTRAL PREMIUM Bedienungsanleitung Seite 31

Configuration set-up menu MISTRAL SYSTEM
e-drive Function
Press briefly 1 × = activate
Press 3 seconds = confirm
Note:
If the e-drive is pressed briefly 1x without confirming it, the values will not be saved.
Switch on the mains.
Stand-by mode
3 seconds
Temperature unit
1× briefly
Temperature limit 45 °C – 650 °C
1× briefly
Heating interface target
1× briefly
Potentiometer
e-drive
Operating mode
Increase temperature turn to the right
Decrease temperature turn to the left
0 – 10 volt
Function
turn to the right
turn to the left
Set-up menu
Press 2 seconds and at the same
& time slowly give it a 1/4 -turn to
the right.
4 –20 mA
Next page
3 seconds
3 seconds
3 seconds
31