Safety Switch Off - Foster 7380645 Installation

Warming

Safety switch off

Protection from
overheating
Timer
If in 10 uninterrupted minutes no cookware is detected on one of the two elements, the
•
bridge function is automatically deactivated.
Deactivation
The end of the Function can be done by repeating the simultaneous selection of both
•
cooking elements (the same as activation).
If the function is deactivated while in operation, than both cooking elements go to level
•
and can then be set again.
The warming function is used to keep cooked food warm. Hence this function can also be
used as melting or simmer function.
Activation
Press of a cooking zone activates the "warming"
•
If is pressed a second time "warming" function ends
•
Maximum continuous operation of a particular hotplate is limited, and the duration is
displayed in the above chart. When the hotplate is switched off by the safety mechanism,
the indicator displays symbols
Power setting
Warming
1
2
3
4
5
6
7
8
9
P
Example:
Set the hotplate to power level 5 and leave it operate for some time. If you do not change
the above setting, the safety mechanism will switch the hotplate off after 210 minutes.
Induction hotplate is also fitted with safety device against overheating which protects
electronic parts from damages. This device operates on several levels. When temperature
of the hotplate excessively rises, it switches on two-stage fan. If this is not enough, extra
powerful heating is deactivated, and finally the safety device either reduces the heating
power of certain hotplates or turns them off completely. When the hotplate cools off, the
full power of hotplate is again available.
Use a timer facilitates cooking by setting the time of hotplate operation. For each zone it's
possible to set an independent timer
Activation
The cooktop must be turned on and the zone where you want to set the timer must be
•
working.
Simultaneously press
•
first active cooking zone from the left, lights on
• Simultaneously press
you want to set the timer .
Within 10 seconds since pressing
•
or .
The value of the timer can be displayed:
•
in minutes and seconds up to 9min59sec;
-
in hours and minutes up to 9h59min, in this case the word "min" is shown under
-
the timer's display.
, or in case there is any remaining heat left.
Minutes lapse prior safety switch off
120
522
402
318
258
210
168
138
114
90
10
and , the timer's display shows
and as many times as necessary, to select the zone where
lights on only for active zooking zones.
and
34
;
and
set the timer value by pressing
, of the