ULTIMATE SPEED ULGD 10 A1 Originalbetriebsanleitung Seite 45

Using the device
Program 5
24V
1
(28.8 V / 2.5 A)
To charge 24 V batteries with a
capacity of 20 Ah to 50 Ah.
Press the program selector button
once to select Program 5.
If the 24 V battery is deeply dis-
charger (below 15.6 Volt), then the
charger recognises the battery as
a 12 V battery. In this case, the
program selector button
pressed five times, to select pro-
gram 5.
The and
24V
2
shown on the LC display. During the
charging process, the charging
display flashes. The progress of
9
the charging process (1-4 bars) will
be shown on the status display
When the battery is fully charged,
the status display shows
The flashing stops and the device
switches to trickle charging
automatically. The display will
show "FUL".
Program 6
24V
1
(29.4 V / 2.5 A)
To charge 24 V batteries with a
capacity of 20 Ah to 50 Ah under
44 GB/IE
8
must be
8
symbols are
4
1
.
10
4 bars.
10
cold conditions or to charge AGM
batteries.
Press the program selector button
twice to select Program 6.
If the 24 V battery is deeply dis-
charger (below 15.6 Volt), then the
charger recognises the battery as a
12 V battery. In this case, the
program selector button
pressed six times, to select pro-
gram 6.
The ,
24V
2
1
symbols are shown on the LC
display. During the charging pro-
cess, the charging display
flashes. The progress of the charg-
ing process (1-4 bars) will be shown
on the status display
battery is fully charged, the status
display shows
10
ing stops and the device switches to
trickle charging automatically.
The display will show "FUL".
Program 7
24V
2
(28.8 V / 5.0 A)
To charge 24 V batteries with a
capacity of 40 Ah to 100 Ah.
To maintain the charge of 24 V
batteries up to 150 Ah.
Press the program selector button
three times to select Program 7.
must be
8
and
4 6
9
. When the
10
4 bars. The flash-
8
8