Choosing A Suitable Location - hanseatic HWC31GCIA Gebrauchsanleitung

1. Move the appliance using a dolly or with a
second person.
2. Unpack the appliance and carefully re-
move all packaging, plastic moulding,
adhesive strips, protective film and foam
padding from the inside, outside and back
of the appliance.

Choosing a suitable location

WARNING
Risk of fi re and explosion!
Your appliance"s refrigeration circuit
contains the environmentally-friend-
ly, but fl ammable refrigerant R600a
(isobutane).
Keep the appliance away from open
■
fl ames and hot surfaces.
Dangers from the refrigerant!
Do not damage the refrigerant cir-
■
cuit, for example by piercing the re-
frigerant channels of the condensate
vaporiser with sharp objects, bending
the tubing, etc.
Refrigerant is fl ammable when spurt-
■
ing out and can damage the eyes. In
this case, rinse your eyes in clean wa-
ter and seek medical assistance im-
mediately.
Start-up
NOTICE
Risk of damage!
The appliance may not operate proper-
ly if exposed to low ambient tempera-
tures for extended periods of time. This
can then lead to an increase in temper-
ature inside the appliance.
Always ensure the ambient tempera-
■
ture is kept within the specifi ed range
(see "Intended use" on page EN-4)
– To prevent the formation of a flammable
gas-air mixture in the event of a leakage
in the refrigeration circuit, the installation
space must have a minimum size of 4.5 m³.
– The appliance must only be placed on a
level and firm surface. The surface must be
strong enough to support the appliance"s
weight when fully laden.
– Suitable locations are dry, well-ventilated
areas that are cool if possible.
– Unsuitable locations are ones with direct
sunlight or which are directly next to an ov-
en, hob or radiator.
– The following minimum distances must be
maintained:
– from electrical hobs
– from oil and coal burning stoves 100 cm
– from other cooling appliances
– from washing machines/
dishwashers
– If you would like to reduce these distances,
you can fit an insulation plate between the
appliances.
– If underfloor heating is installed at the set-
up location, place the cooling appliance on
an insulation plate made from solid material.
Page EN-19
20 cm
20 cm
20 cm