Safety Lock (Child Safety Lock); Setting The Temperature; Changing The Temperature Unit; Led Light - hanseatic HWC31GCIA Gebrauchsanleitung

Page EN-12 Operation

Safety lock (child safety lock)

The appliance is equipped with a safety lock.
When this is activated, no settings can be
changed.
• To activate the safety lock, press the
(7) and (8) keys at the same time.
A beep will sound. The safety lock is now
activated.
• To deactivate the safety lock, press the
(7) and (8) keys again at the same
time.
A beep will sound. The safety lock is now
deactivated.

Setting the temperature

WARNING
Health hazard!
The appliance may not operate proper-
ly if exposed to low ambient tempera-
tures for extended periods of time. This
can then lead to an increase in temper-
ature inside the appliance.
Always ensure the prescribed ambi-
■
ent temperature is maintained (see
"Intended use" on page EN-4).
Select an internal temperature to suit the
wine. Further information on the optimum
storage temperature can be found in the sec-
tion "Maintaining quality" on page EN-15.
You can set the appliance to a temperature
from +5 °C to +22 °C (41 °F to 72 °F).
The temperature for the lower range can only
be set equal to or higher than the temperature
in the upper range.
If the same temperature is set in the upper
and lower ranges, the actual temperature in
the lower range is 1 to 2 degrees higher than
the actual temperature in the upper range.
1. Select the desired interior zone by press-
ing the key (9)
– once for the upper zone. The left-hand
temperature indicator (10) will flash.
– twice for the lower zone.
– The right-hand temperature indica-
tor (10) will flash.
As long as the temperature indicator is
flashing, you can set the temperature.
2. The temperature of the selected zone can be
– increased by pressing the
til the desired temperature is displayed.
– reduced by pressing the
the desired temperature is displayed.
After a short while the flashing will stop and
the desired temperature will be set.
The appliance will adjust itself to the set
temperature while showing the current in-
ternal temperature.
If you set a lower temperature, you
will need higher cooling performance.
This increases the energy consumption.

Changing the temperature unit

You can choose whether the internal temper-
ature is displayed in Celsius or in Fahrenheit.
The small green symbol on the top right next
to the temperature indicator (10) lets you
identify the current setting.
• To change the unit, press an hold the
key (13).
C
F

LED light

• To switch the LED on or off, press the
key (8).
key (11) un-
key (12) until