Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3
Safety Instructions
All applicable accident prevention rules and regulations as well as other recognised
industrial safety and health rules and regulations must be observed at all times.
Use the spray gun only in well-ventilated rooms. Fire, naked flames and smoking are
strictly prohibited within the working area. WARNING – during the spraying of flam-
mable materials (e.g. lacquers, adhesives, cleaning agents, etc.), there is an increa-
sed risk to health as well as an increased risk of explosion and fire.
Measures must be taken to ensure that the spray gun is sufficiently grounded (eart-
hed) by means of a conductive air hose (maximum resistance 10
Before carrying out maintenance or servicing work, always ensure that the air and
material feed to the spray gun have been depressurised. Risk of injury!
When spraying materials, do not place your hands or other parts of the body in front
of the pressurised nozzle or the spray gun. Risk of injury!
Never point the spray gun at persons or animals. Risk of injury!
Always observe the spraying and safety instructions given by the manufacturers of
the spraying material and the cleaning agent. Aggressive and corrosive materials in
particular can be harmful to health.
Exhaust air containing particles (overspray) must be kept away from the working area
and personnel. In spite of these measures, always wear the regulation breathing
masks and protective overalls when using the gun. Airborne particles represent a
serious health hazard!
Always wear hearing protection when using the gun or when in the vicinity of a gun
that is in use. The noise level generated by the spray gun is approx. 83 dB (A).
After carrying out assembly or maintenance work, always ensure that all nuts, bolts
and screw connections have been fully tightened before the gun is used.
Use only original replacement parts, since WALTHER can only guarantee safe and
fault-free operation for original parts.
For further information on the safe use of the spray gun and the spraying materials,
please contact WALTHER Spritz- und Lackiersysteme GmbH, D-42327 Wuppertal,
Germany.
4
Ω).
6
l
l
4
Assembly
The spray gun is delivered fully assembled. Before using it, the following steps
should be carried out:
4.1
Mounting of Spray Gun
Install the gun in a suitable and stable mounting device. Use the centre hole of the
housing for locate the gun.
4.2
Connection of Input Lines
Warning
Make sure not to confuse the control and atomizing air connections -risk of injury.
Warning
Material and air hoses which are installed with a hose grommet must be additionally
secured with a hose clamp.
M
SP
ST 1
ST2
Z
ST 3
5
Operational Handling
5.1
Safty Iinstructions
Please pay special attention to the following safety warnings prior to taking this
spray gun into operation!
• Wear proper respiratory protection masks and protective overalls, whenever you
are operating this spray gun. Air-borne particles represent a health hazard.
• Make sure to wear suitable haering protectors. The gun produces sound levels of
up to 83 dB (A) which may cause hearing defects.
• Open fires, naked lights and smoking prohibited in the working area. Spraying of
readily flammable media such as paints and adhesive compounds is always
accompanied by the risk of fire and explosion.
M
= Material connection (QSM-M5-6)
SP
= Scavenger connection(QSML-M5-4)
ST 1 = Control air connetion (QSM-M5-4):
Material open and scavenger close
ST 2 = Control air connection (QSML-M5-4):
Material close and scavenger open
Z
= Atomising air connection
(M 3-4 mm ø)
ST 3 = Control air connection
(M 3-2 mm ø): Material needle open
The spray gun is now properly installed and
ready for operation.
5
Werbung
Inhaltsverzeichnis
