Olivetti Fax_Lab 145 D Bedienungsanleitung Seite 85

EG
-KONFORMITÄTSERKLÄRUNG des HERSTELLERS nach ISO/IEC 17050
MANUFACTURER'S CE DECLARATION of CONFORMITY according to ISO/IEC 17050
OLIVETTI S.p.A
Erklärt in eigener Verantwortung, dass:
Declares under its sole responsibility that:
das in diesem Handbuch beschriebene Produkt
the product described in this guide
mit der EG-Richtline 1999/5 vom 9. März 1999 konform ist
is in compliance with directive 99/5/EC dated 9
und die wesentlichen Anforderungen für die Elektromagnetische Kompatibilität und die Elektrische Sicherheit
erfüllt, die durch die Richtlinien vorgesehen sind:
fulfill the essential requirements of Electromagnetic Compatibility and of Electrical Safety as prescribed by the
Directives:
89/336/EWG vom 3. Mai 1989 mit den nachfolgenden Änderungen (EWG-Richtlinie 92/31 vom 28. April 1992
und EWG-Richtlinie vom 22. Juli 1993);
rd
89/336/EEC dated 3 May 1989 with subsequent amendments (Directive 92/31/EEC dated 28
nd
93/68/EEC dated 22 July 1993);
2006/95/EG vom 27. Dezember 2006;
th
2006/95/EC dated 27 December 2006;
da geplant und hergestellt in Konformität mit den folgenden aufeinander abgestimmten Normen:
since designed and manufactured in compliance with the following European Harmonized Standards:
EN 55022/A2 : 2003 (Limits and methods of measurements of radio interference characteristics of Information Technology
Equipment) / Class B;
EN 61000-3-2/A1 : 2002 (Electromagnetic Compatibility (EMC) - Part 2 : Limits - Section 2 : Limits for harmonic current
emissions (equipment input current ≤ 16 A per phase);
EN 61000-3-3/A1 : 2002 (Electromagnetic Compatibility (EMC) - Part 3 : Limits - Section 3 : Limitation of voltage
fluctuations and flicker in low voltage supply systems for equipment with rated current up to and including 16A);
EN 55024/A1 : 2002 (Electromagnetic Compatibility - Information technology equipment - Immunity characteristics -
Limits and methods of measurement);
EN 60950-1/A1 : 2004 (Safety of Information Technology Equipment, including electrical business equipment).
Und desweiteren mit den folgenden Normen konform ist:
Moreover the model is in compliance with following Standards:
ETSI TBR 38 : May 1998 Requirements for a terminal equipment incorporating an analogue handset function capable of
supporting the justified case service when connected to the analogue interface of the PSTN in Europe.
ETSI ES 203 021 : January 2006 Access and Terminal (AT); Harmonized basic attachment requirements for Terminals for
connection to analogue interfaces of the Telephone Networks.
ETSI EN 301 406 : 2003 Digital Enhanced Cordless Telecommunications (DECT); Harmonized EN for Digital Enhanced
Cordless Telecommunications covering essential requirements under article 3.2 of the R&TTE Directive Generic radio.
ETSI EN 301 489-6 : 2002 Electromagnetic compatibility and radio spectrum Matters (ERM); Electromagnetic
compatibility (EMC) standard for radio equipment and services; Part6: specific conditions for Digital Enhanced Cordless
Telecommunications (DECT) equipment.
ETSI EN 301 489-1 : 2005 Electromagnetic compatibility and radio spectrum Matters (ERM); Electromagnetic
compatibility (EMC) standard for radio equipment and services; Part1: Common technical requirements.
Die Konformität zu den o. g. wesentlichen Anforderungen wird durch die Anbringung der Marke EG auf dem
Produkt bescheinigt.
Compliance with the above mentioned essential requirements is shown by affixing the CE marking on the product.
Scarmagno, 08. März 2007
th
Scarmagno, 8 march 2007
Hinweis: 1) Die Marke EG wurde 2007 angebracht.
Notes: 1) CE Marking has been affixed in 2007.
2) Das Qualitätssystem entspricht dem Serienstandard UNI EN ISO 9000.
2) The Quality System is in compliance with the UNI EN ISO 9000 series of Standards.
Olivetti S.p.A. Sede Sociale Ivrea,Via Jervis,77 – Cap. Soc. Euro 154.000.000 – C.C.I.A.A. Torino n. 547040 – Trib Ivrea Reg. Soc. n. 1927 – Cod. Fisc. e Part. IVA 02298700010
Via Jervis, 77 - IVREA (TO) - ITALY
th
march 1999
th
April 1992 and Directive
Olivetti S.p.A.